Home › BODY › EXTERIOR › BACK DOOR OUTSIDE GARNISH

BACK DOOR OUTSIDE GARNISH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE BACK DOOR LOWER TRIM BOARD ASSEMBLY


B075175E04
  1. Attach the 11 clips to install the lower trim board.



3. REMOVE BACK DOOR OUTSIDE GARNISH
  1. Disconnect the back door opener switch connector.



  1. Remove the 4 nuts.


    B133842E01

  1. Using a screwdriver, detach the 2 clips and remove the garnish (with back door opener switch).

    HINT:
    Tape the screwdriver tip before use.



    B067629E01
  1. Remove the 2 screws and back door opener switch from the garnish.