FRONT BUMPER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT FENDER LINER LH |
![]() |
Using a clip remover, remove the clip.
Partially remove the fender liner.
| 3. REMOVE FRONT FENDER LINER RH |
| 4. REMOVE CENTER NO. 4 ENGINE UNDER COVER |
![]() |
Remove the 5 screws, 4 bolts and under cover.
| 5. REMOVE FRONT SPOILER COVER |
![]() |
Remove the 7 screws and spoiler cover.
| 6. REMOVE FRONT BUMPER COVER |
![]() |
Put protective tape under the front fender.
Using a clip remover, remove the 3 clips.
Remove the 2 radiator grille protectors and 4 screws.
Detach the 8 claws.
![]() |
Detach the 4 claws and remove the bumper cover.
Hold the front bumper cover on its upper and lower parts with your hands as shown in the illustration.
Pull up the front bumper cover's lower part while holding its upper part securely.
w/ Fog light:
Disconnect the 2 fog light connectors.
| 7. REMOVE FRONT BUMPER ENERGY ABSORBER |
| 8. REMOVE FRONT BUMPER REINFORCEMENT |
Using a screwdriver, remove the 4 wire harness clamps.
Remove the 4 nuts and reinforcement.
| 9. REMOVE FRONT BUMPER SIDE SUPPORT LH |
Remove the 2 screws and side support.
| 10. REMOVE FRONT BUMPER SIDE SUPPORT RH |
Remove the 2 screws and side support.