Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



2. REMOVE FRONT DOOR SCUFF PLATE LH


    B073586E02
  1. Using a screwdriver, detach the 8 claws and 2 clips, and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR DOOR SCUFF PLATE LH


    B073587E02
  1. Using a screwdriver, detach the 6 claws and clip, and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH


5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


6. REMOVE CENTER PILLAR GARNISH LOWER LH


    B073589E03
  1. Using a screwdriver, detach the 2 claws and 2 clips, and remove the lower garnish.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
  1. Remove the anchor cover and floor anchor bolt.

  1. Remove the nut and shoulder anchor.



    B074545E01
  1. Disconnect the pretensioner connector.

  1. Remove the 2 bolts and outer belt.



8. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH


H043789E03
  1. Remove the 2 nuts and sensor.

  1. Disconnect the connector.