Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER


B074061E02
  1. Using a clip remover, remove the clip from the instrument panel finish panel lower center.

  1. Detach the 4 claws and 2 clips, and remove the instrument panel finish panel.



3. REMOVE NO. 3 AIR DUCT REAR


4. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


H043784E02
  1. Remove the 3 bolts and airbag sensor.

  1. Disconnect the airbag sensor connectors.