Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SEAT POSITION SENSOR

SEAT POSITION SENSOR > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT SEAT ASSEMBLY
  1. Remove the front seat assembly (Click here).



3. REMOVE SEAT POSITION SENSOR


H043792E03
  1. Remove the seat slide position sensor protector.

  1. Disconnect the connector.

  1. Using a T30 "torx" socket, remove the screw and seat position sensor.