Home › ENGINE › 1NZ-FXE ENGINE MECHANICAL › TIMING CHAIN

TIMING CHAIN > INSPECTION

for Preparation Click here



1. INSPECT CHAIN


    A050062E01
  1. Using a spring scale, pull the timing chain with a force of 140 N (14.3 kgf, 31.5 lbf) and measure the length of it.

    Maximum chain elongation:
    124.2 mm (4.890 in.)

    If the elongation is greater than the maximum, replace the chain.

    HINT:
    Perform the measurements at 3 or more random places to obtain the average length.



2. INSPECT NO. 1 CHAIN TENSIONER


    A011223E02
  1. Check that the plunger moves smoothly when the ratchet pawl is raised with your finger.

  1. Release the ratchet pawl and check that the plunger is locked in place by the ratchet pawl and does not move when pushed with your finger.



3. INSPECT CHAIN TENSIONER SLIPPER


    A037065E01
  1. Measure the chain tensioner slipper wear.

    Maximum wear:
    1.0 mm (0.039 in.)

    If the wear is greater than the maximum, replace the slipper.



4. INSPECT NO. 1 CHAIN VIBRATION DAMPER


    A037066E01
  1. Measure the vibration damper wear.

    Maximum wear:
    1.0 mm (0.039 in.)

    If the wear is greater than the maximum, replace the damper.