Home › BODY › SEAT › REAR SEAT ASSEMBLY

REAR SEAT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL REAR SEATBACK CENTER HINGE SUB-ASSEMBLY


    B076041
  1. Install the hinge with the 2 bolts.

    Torque:
    18.1 N*m{ 185 kgf*cm , 13 ft.*lbf }



2. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY LH
  1. Install the hinge with the bolt.

    Torque:
    18.1 N*m{ 185 kgf*cm , 13 ft.*lbf }



3. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY RH
  1. Install the hinge with the bolt.

    Torque:
    18.1 N*m{ 185 kgf*cm , 13 ft.*lbf }



4. INSTALL REAR SIDE SEATBACK ASSEMBLY LH
  1. Install the side seatback with the bolt.



5. INSTALL REAR SIDE SEATBACK ASSEMBLY RH
  1. Install the side seatback with the bolt.



6. INSTALL REAR DOOR SCUFF PLATE LH


    B073587E02
  1. Attach the 6 claws and clip to install the scuff plate.



7. INSTALL REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.



8. INSTALL REAR SEATBACK ASSEMBLY LH


    B076029E01
  1. Install the seatback with the 2 bolts.

    Torque:
    36.8 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Close the front part of the rear No. 1 floor deck board.

  1. Return the seatback to the upright position.



9. INSTALL REAR SEATBACK ASSEMBLY RH


    B076028E01
  1. Install the seatback with the 2 bolts.

    Torque:
    36.8 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Close the front part of the rear No. 1 floor deck board.

  1. Return the seatback to the upright position.

  1. Connect the rear seat outer belt floor anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



10. INSTALL REAR SEAT CUSHION ASSEMBLY

NOTICE:
When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.



    B132601E01
  1. Attach the seat cushion's rear hook to the center hinge.

  1. Insert the inner belts through the slits on the seat cushion.



    B132602
  1. Attach the seat cushion's 2 front hooks to the vehicle body.

  1. Confirm that the seat cushion is firmly installed.