Home › BODY › EXTERIOR › FRONT DOOR WINDOW FRAME MOULDING

FRONT DOOR WINDOW FRAME MOULDING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. When installing the moulding, heat the vehicle body and moulding using a heat light.

    Standard heating temperature:
    Item
    Specified Condition
    Vehicle Body
    40 to 60°C (104 to 140°F)
    Moulding
    20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body and moulding excessively.



1. INSTALL FRONT DOOR WINDOW FRAME REAR MOULDING LH
  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body.

    2. Remove the double-sided tape from the vehicle body.

    3. Wipe off any tape adhesive residue with white gasoline.



  1. If reusing the moulding:
    Clean the moulding and install new double-sided tape.

    1. Using a heat light, heat the moulding.

    2. Remove the double-sided tape from the moulding.

    3. Wipe off any tape adhesive residue with white gasoline.



    4. B074182E03
    5. Install new double-sided tape to the moulding.

      NOTICE:
      Install the double-sided tape exactly according to the specifications below.

      Standard measurement:
      Area
      Specified Condition
      A
      (1) 440.0 mm (17.323 in.)
      (2) 37.0 mm (1.457 in.)
      B
      5.0 mm (0.197 in.)
      C
      0.8 mm (0.032 in.)

  1. Install the moulding.

    1. Using a heat light, heat the vehicle body and moulding.

    2. Remove the peeling paper from the face of the moulding.

      NOTICE:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    3. Install the moulding with the screw.

      NOTICE:
      Do not apply excessive force to the moulding. Apply steady pressure with your thumbs.