Home › BODY › EXTERIOR › FRONT DOOR WINDOW FRAME MOULDING

FRONT DOOR WINDOW FRAME MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. When removing the moulding, heat the vehicle body and moulding using a heat light.

    Standard heating temperature:
    Item
    Specified Condition
    Vehicle Body
    40 to 60°C (104 to 140°F)
    Moulding
    20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body and moulding excessively.



1. REMOVE FRONT DOOR WINDOW FRAME REAR MOULDING LH


    B074180E02
  1. Remove the screw.

  1. Using a heat light, heat the moulding and vehicle body.

  1. Cut the double-sided tape that holds the moulding to the vehicle body with a knife.

    NOTICE:
    1. If reusing the moulding, take care not to damage the moulding.
    2. Be careful not to damage the vehicle body.

  1. Remove the moulding.