Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0121    Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance Problem

for Preparation Click here


DESCRIPTION

Refer to DTC P0120 .

HINT:
This is the purpose of troubleshooting the throttle position sensor.


DTC No.
DTC Detection Condition
Trouble Area
P0121
Difference between VTA1 and VTA2 is out of threshold for 2 seconds
Throttle position sensor

MONITOR DESCRIPTION

The ECM uses the throttle position sensor to monitor the throttle valve opening angle.
This sensor has two signals, VTA1 and VTA2. VTA1 is used to detect the throttle opening angle and VTA2 is used to detect malfunctions in VTA1. There are several checks that the ECM confirms proper operation of the throttle position sensor and VTA1.
There is a specific voltage difference between VTA1 and VTA2 for each throttle opening angle.
If VTA1 or VTA2 is out of the normal operating range, the ECM interprets this as a fault and will set a DTC.
If VTA1 is within 0.02 V of VTA2, the ECM interprets this as a short circuit in the throttle position sensor system and will set a DTC.
If the voltage output difference between the VTA1 and VTA2 deviates from the normal operating range, the ECM interprets this as malfunction of the throttle position sensor. The ECM will turn on the MIL and a DTC will be set.

FAIL-SAFE

If the Electronic Throttle Control System (ETCS) has a malfunction, the ECM cuts off current to the throttle control motor. The throttle control valve returns to a predetermined opening angle (approximately 16°) by the force of the return spring. The ECM then adjusts the engine output by controlling the fuel injection (intermittent fuel-cut) and ignition timing in accordance with the accelerator pedal opening angle to enable the vehicle to continue to drive.
If the accelerator pedal is depressed firmly and slowly, the vehicle can be driven slowly.
If a "pass" condition is detected and then the power switch is turned OFF, the fail-safe operation will stop and the system will return to normal condition.

MONITOR STRATEGY


Related DTCs
P0121: Throttle position sensor rationality
Required sensors/components
Throttle position sensor
Frequency of operation
Continuous
Duration
2 seconds
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
None
Either of the following conditions is met
A or B
A. Power switch
ON (IG)
B. Electronic throttle motor power
ON
TP sensor malfunction (P0120, P0122, P0123, P0220, P0222, P0223, P2135)
Not detected

TYPICAL MALFUNCTION THRESHOLDS


Difference of TP sensor voltage between VTA1 and VTA2 x 0.8
Less than 0.8 V and more than 1.6 V

INSPECTION PROCEDURE

HINT:
Read freeze frame data using Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air/fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

1.CHECK ANY OTHER DTCS OUTPUT
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / Trouble Code.

  1. Read the DTCs.

    Result:
    Display (DTC output)
    Proceed To
    P0121
    A
    P0121 and other DTCs
    B



B
GO TO DTC CHART
A

REPLACE THROTTLE W/MOTOR BODY ASSEMBLY