Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0336-137    Crankshaft Position Sensor "A" Circuit Range / Performance

DTC    P0340-532    Camshaft Position Sensor "A" Circuit

for Preparation Click here


DESCRIPTION

If there is any malfunction in the communication values or pulse inputs, the HV control ECU detects it by comparing the following three speeds: the engine speed transmitted by the ECM via CAN (Controller Area Network) communication, the engine speed obtained through pulse inputs, and the engine speed calculated from the MG1 and MG2 speeds.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0336
137
Engine speed sensor deviation malfunction (CAN communication)
  1. Wire harness or connector
  2. Crankshaft position sensor
  3. Camshaft position sensor
  4. HV control ECU
P0340
532
Engine speed sensor deviation malfunction (pulse signal)
  1. Wire harness or connector
  2. Crankshaft position sensor
  3. Camshaft position sensor
  4. HV control ECU

WIRING DIAGRAM


A182521E01


INSPECTION PROCEDURE

1.READ OUTPUT DTC (ENGINE)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Engine Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTCs are output.



YES
GO TO RELEVANT DTC CHART
NO


2.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - ECM)


    A065745E34
  1. Disconnect the H16 HV control ECU connector.



    A065744E18
  1. Disconnect the E7 ECM connector.

  1. Measure the resistance between the wire harness side connectors.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    NEO (H16-12) - NEO (E7-1)
    Below 1 Ω
    GO (H16-13) - GO (E7-2)
    Below 1 Ω
    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    NEO (H16-12) or NEO (E7-1) - Body ground
    10 kΩ or higher
    GO (H16-13) or GO (E7-2) - Body ground
    10 kΩ or higher

  1. Reconnect the ECM connector.

  1. Reconnect the HV control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT CRANKSHAFT POSITION SENSOR
  1. Inspect crankshaft position sensor .



NG
REPLACE CRANKSHAFT POSITION SENSOR
OK


4.INSPECT CAMSHAFT POSITION SENSOR
  1. Inspect camshaft position sensor .



NG
REPLACE CAMSHAFT POSITION SENSOR
OK

REPLACE HYBRID VEHICLE CONTROL ECU