Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A09-591    DC / DC Converter Status Circuit Low Input

DTC    P0A10-592    DC / DC Converter Status Circuit High Input

for Preparation Click here


DESCRIPTION

See the description of the DC / DC converter .
The HV control ECU sends the output voltage switch signal to the DC / DC converter via the VLO signal line in order to switch output voltage according to vehicle status.
If the vehicle is being driven with an inoperative DC / DC converter, the voltage of the auxiliary battery will drop, which will prevent the continued operation of the vehicle. Therefore, the HV control ECU monitors the operation of the DC / DC converter and alerts the driver if it detects a malfunction.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A09
591
Open or GND short in VLO signal circuit of DC / DC converter
  1. Wire harness or connector
  2. Inverter with converter assembly
P0A10
592
+B short in VLO signal circuit of DC / DC converter
  1. Wire harness or connector
  2. Inverter with converter assembly

WIRING DIAGRAM


A092298E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - DC / DC CONVERTER)


    A065745E36
  1. Disconnect the H16 HV control ECU connector.



    A092030E02
  1. Disconnect the C5 DC / DC converter connector.

  1. Turn the power switch ON (IG).

  1. Measure the voltage between the terminal of the HV control ECU connector and body ground.

    Standard voltage:
    Tester Connection
    Specified Condition
    VLO (H16-31) - Body ground
    Below 1 V

  1. Turn the power switch OFF.

  1. Measure the resistance between the wire harness side connectors.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    VLO (H16-31) - VLO (C5-5)
    Below 1 Ω
    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    VLO (H16-31) or VLO (C5-5) - Body ground
    10 kΩ or higher

  1. Reconnect the DC / DC converter connector.

  1. Reconnect the HV control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INVERTER WITH CONVERTER ASSEMBLY