Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A0F-204    Engine Failed to Start

DTC    P0A0F-205    Engine Failed to Start

DTC    P0A0F-533    Engine Failed to Start

DTC    P0A0F-534    Engine Failed to Start

for Preparation Click here


DESCRIPTION

The HV control ECU performs the fail-safe control, when the ECM detects an error which will affect THS control.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A0F
204
Abnormal signal input from ECM (abnormal engine output)
  1. ECM
  2. SFI system
P0A0F
205
Abnormal signal input from ECM (engine is unable to start)
  1. ECM
  2. SFI system
P0A0F
533
Abnormal signal input from ECM (abnormal engine output by running out of fuel)
  1. ECM
  2. SFI system
P0A0F
534
Abnormal signal input from ECM (engine is unable to start by running out of fuel)
  1. ECM
  2. SFI system

INSPECTION PROCEDURE

1.READ OUTPUT DTC (ENGINE)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Engine Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTCs are output



NG
GO TO RELEVANT DTC CHART
OK

REPLACE ECM