Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1D-140    Hybrid Powertrain Control Module

for Preparation Click here


DESCRIPTION

The HV control ECU performs self-checks to detect an internal operating malfunction in the ECU.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1D
140
HV control ECU internal error
  1. HV control ECU

MONITOR DESCRIPTION

The HV control ECU performs many diagnostic tests to verify proper operation of internal ECU systems. One of these tests checks for errors after a memory read / write diagnostic test.
If the HV control ECU detects this malfunction inside of the ECU, it will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A1D (INF 140): RAM destruction
Required sensor / components
Hybrid vehicle control ECU
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


All RAM area
Read / write check error

COMPONENT OPERATING RANGE


Hybrid vehicle control ECU
DTC P0A1D (INF 140) is not detected

INSPECTION PROCEDURE

If the above information (INF) code is present, replace the HV control ECU.
1.REPLACE HYBRID VEHICLE CONTROL ECU
  1. Replace the hybrid vehicle control ECU .


NEXT

COMPLETED