Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1D-142    Hybrid Powertrain Control Module

for Preparation Click here


DESCRIPTION

When the ST turned ON in the ignition switch on the previous model, the ignition switch transmitted the ST signal to the HV control ECU.
The new Prius has adopted a push button start system. When the driver pushes on the power switch while depressing the brake pedal, the power source control ECU transmits the ST signal to the HV control ECU.

A093723E01

The HV control ECU monitors the ST signal to detect malfunction. If the ST signal is shorted to the +B power supply, the ST will be constantly ON, which will cause the HV system to start by merely turning the power switch ON (IG). The HV control ECU monitors the ST signal to prevent this from occurring.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1D
142
ST signal of HV control ECU is ON with power switch OFF
  1. Wire harness or connector
  2. Power source control ECU

MONITOR DESCRIPTION

The HV control ECU monitors an ST signal input from the power source control ECU. If the ST signal is shorted to the +B power supply, the HV control ECU interprets this as the ST signal error, and then illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A1D (INF142): ST malfunction
Required sensor / components
Power source control ECU
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


ST signal
ON

COMPONENT OPERATING RANGE


ST signal
OFF (when the power switch OFF)

WIRING DIAGRAM


A092096E01


INSPECTION PROCEDURE

1.INSPECT HYBRID VEHICLE CONTROL ECU (ST2 VOLTAGE)
A065748E29
  1. Disconnect the H14 HV control ECU connector.

  1. Measure the voltage between the terminal of the HV control ECU connector and body ground with the power switch turned OFF.

    Standard voltage:
    Tester Connection
    Specified Condition
    ST2 (H14-5) - Body ground
    Below 1 V

  1. Reconnect the HV control ECU connector.



OK
CHECK FOR INTERMITTENT PROBLEMS
NG


2.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - POWER SOURCE CONTROL ECU)


    A065748E29
  1. Disconnect the H14 HV control ECU connector.



    A092032E01
  1. Disconnect the P6 power source control ECU connector.

  1. Measure the voltage between the terminal of the HV control ECU connector or power source control ECU and body ground with the power switch turned OFF.

    Standard voltage:
    Tester Connection
    Specified Condition
    ST2 (H14-5) or STSW (P6-39) - Body ground
    Below 1 V

  1. Reconnect the power source control ECU connector.

  1. Reconnect the HV control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER SOURCE CONTROL ECU