Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1D-134    Hybrid Powertrain Control Module

DTC    P0A1D-135    Hybrid Powertrain Control Module

DTC    P0A1D-570    Hybrid Powertrain Control Module

for Preparation Click here


DESCRIPTION

The HV control ECU performs self-checks to detect an internal operating malfunction in the ECU.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1D
134
135
570
HV control ECU internal error
  1. HV control ECU

MONITOR DESCRIPTION

The HV control ECU performs diagnostic monitoring to verify proper operation of vehicle systems.
One of these monitors the rationality of internal analog (signal) to digital conversions.
The HV control ECU monitors the internal A/D (Analog / Digital Converter) value. If there is an A/D malfunction, the HV control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A1D (INF 134 / 135 / 570):
ADC malfunction
Required sensor / components
Hybrid vehicle control ECU
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


Hybrid vehicle control ECU
Internal error

COMPONENT OPERATING RANGE


Hybrid vehicle control ECU
DTC P0A1D (INF 134 / 135 / 570) is not detected

INSPECTION PROCEDURE

If any of the above information (INF) codes are present, replace the HV control ECU.
1.REPLACE HYBRID VEHICLE CONTROL ECU
  1. Replace the hybrid vehicle control ECU .


NEXT

COMPLETED