Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A0D-350    High Voltage System Inter-Lock Circuit High

for Preparation Click here


DESCRIPTION

If the HV control ECU detects the operation of the safety devices (removal of the service plug grip and inverter cover) while the vehicle is stopped (vehicle speed below 3 mph [5 km/h]), it will shut down the system main relays. If the safety devices are correctly reinstalled, it will resume the normal operation after the power source is supplied again. If it does not, there is a possibility of an open circuit, so perform the same inspection as the DTC P0A0D (INF 351).

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A0D
350
Operating safety devices with vehicle stopped (ILK signal is ON)
  1. Service plug grip installation
  2. Inverter cover installation

INSPECTION PROCEDURE

1.CHECK SERVICE PLUG GRIP INSTALLATION
  1. Check that the service plug grip has been installed properly.

    OK:
    The service plug grip has been installed properly



NG
CORRECTLY REINSTALL
OK


2.CHECK INVERTER COVER INSTALLATION
  1. Check that the inverter cover has been installed properly.

    OK:
    The Inverter cover has been installed properly



NG
CORRECTLY REINSTALL
OK

GO TO DTC P0A0D-351