Home › HYBRID SYSTEM › P112 HYBRID BATTERY CONTROL › HYBRID BATTERY SYSTEM

HYBRID BATTERY SYSTEM > DEFINITION OF TERMS

for Preparation Click here



DEFINITION OF TERMS

Term
Definition
Duration
The minimum time that the battery ECU must sense a continuous deviation in the monitored value(s) before setting a DTC. This timing begins after the "typical enabling conditions" are met
Frequency of operation
The number of times that the battery ECU checks for malfunction per driving cycle
"Once per driving cycle" means that the battery ECU detects malfunction only one time during a single driving cycle
"Continuous" means that the battery ECU detects malfunction every time when enabling condition is met
MIL operation
MIL illumination timing after a defect is detected
"Immediate" means that the battery ECU illuminates the MIL the instant the battery ECU determines that there is malfunction
"2 driving cycles" means that the battery ECU illuminates the MIL if the same malfunction is detected again in the 2nd driving cycle
Monitor description
Description of what the battery ECU monitors and how it detects malfunction (monitoring purpose and its details)
Related DTCs
A group of DTCs that is classified by a system and a troubleshooting procedure
Required sensor/components
The sensors and components that are used by the battery ECU to detect malfunction
Sequence of operation
The priority order that is applied to monitoring, if multiple sensors and components are used to detect the malfunction
While another sensor is being monitored, the next sensor or component will not be monitored until the previous monitoring has concluded
Typical enabling condition
Preconditions that allow the battery ECU to detect malfunction
With all preconditions satisfied, the battery ECU sets the DTC when the monitored value(s) exceeds the malfunction threshold(s)
Typical malfunction thresholds
Beyond this value, the battery ECU will conclude that there is malfunction and set a DTC