Home › HYBRID SYSTEM › P112 HYBRID BATTERY CONTROL › HYBRID BATTERY SYSTEM

HYBRID BATTERY SYSTEM > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA

HINT:
The freeze frame data records the operating conditions of the HV battery system and components when the DTC was set. It is used for estimating or simulating the condition of the vehicle when a malfunction occurred.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch ON (IG) and the tester ON.

  3. Enter the following menus: Powertrain / HV Battery / DTC.

  4. Select a DTC in order to display its freeze frame data.

  5. Check the freeze frame data of the DTC that has been detected.


Freeze frame data 
Techstream Display
Measurement Item/Range
Suspected Vehicle Status
When Malfunction Occurs
Coolant Temp
Engine coolant temperature /
Min.: -40°F (-40°C), Max.: 284°F (140°C)
Cold or warm engine
Engine Rev
Min.: 0, Max.: 16383.75
-
Vehicle Spd
Vehicle speed /
Min.: 0 mph (0 km/h), Max.: 158.45 mph (255 km/h)
Stopped, or driving (low, medium, and high speeds)
Engine Run Time
Elapsed time after starting engine /
Min.: 0 s, Max.: 65,535 s
Elapsed time from engine start
+B
Auxiliary battery voltage /
Min.: 0 V, Max.: 65.535 V
Condition of auxiliary battery
DTC Clear Warm
The number of times engine is warmed up after clearing DTCs /
Min.: 0, Max.: 255
Frequency of the malfunction recurrence after clearing DTCs
Battery SOC
State of charge (SOC) of HV battery
Min.: 0%, Max: 100%
-
Delta SOC
SOC variance/
Min.: 0%, Max.: 100%
Difference between maximum and minimum values of SOC at every battery block
IB Battery
Current value of battery pack/
Min.: -327.68 A, Max.: 327.67 A
Charging/discharging condition of HV battery
  1. Discharging amperage indicated by a positive value
  2. Charging amperage indicated by a negative value
Batt Inside Air
Temperature of intake ambient air to battery pack/
Min.: -327.68°C, Max.: 327.67°C
-
VMF Fan Voltage
Battery blower motor voltage/
Min.: 0 V, Max.: 25.4 V
Actuation condition of battery blower motor
AUX. Batt V
Auxiliary battery voltage/
Min.: 0 V, Max.: 25.4 V
Condition of auxiliary battery
WIN
Charge wattage of HV battery/
Min.: -64 kW, Max.: 0 kW
Charge control wattage which is sent from battery ECU to hybrid vehicle control ECU
WOUT
Discharge wattage of HV battery/
Min.: 0 kW, Max.: 63.5 kW
Discharge control wattage which is sent from battery ECU to hybrid vehicle control ECU
Cooling Fan Spd
Battery blower motor drive mode/
Min.: 0, Max.: 6
Stopped: 0
Low to high speed actuation: 1 to 6
ECU Ctrl Mode
ECU control mode/
Min.: 0, Max.: 4
Operating condition of HV battery
SBLW Rqst
Battery blower motor stop control request (standby blower)
-
Batt Temp TB1 to TB3
Temperature of HV battery/
Min.: -327.68°C, Max.: 327.67°C
-
V1 to V14 Batt Block
Battery block voltage/
Min.: -327.68 V, Max.: 327.67 V
Voltage variance among battery blocks
Calc Load
Calculate load/
Min.: 0, Max.: 100
-
Throttle POS
Min.: 0, Max.: 100
-