DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 | Conditions (a) and (b) continue for 2.0 seconds: (a) Throttle control motor output duty is 80% or more (b) Throttle control motor current is less than 0.5 A |
|
| P2103 | Following conditions are met.
|
|
| Related DTCs | P2102: Throttle actuator control motor current (low current) |
| Required sensors/components | Throttle actuator motor |
| Frequency of operation | Continuous |
| Duration | 2 seconds |
| MIL operation | Immediately |
| Sequence of operation | None |
| Related DTCs | P2103: Throttle actuator control motor current (high current) |
| Required sensors/components | Throttle actuator motor |
| Frequency of operation | Continuous |
| Duration | 0.6 seconds |
| MIL operation | Immediately |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | None |
| Throttle motor | ON |
| Difference in motor current between present and 0.016 seconds ago | Less than 0.2 A |
| Duty cycle ratio to open throttle actuator | 80% or more |
| The monitor will run whenever the following DTCs are not present | None |
| Throttle motor | ON |
| Throttle motor current | Less than 0.5 A (when motor drive duty is 80% or more) |
| Hybrid IC | Fail |

| 1.INSPECT THROTTLE W/ MOTOR BODY ASSEMBLY (THROTTLE CONTROL MOTOR) |
![]() |
Disconnect the throttle control motor connector.
Measure the motor resistance between terminals 1 (M-) and 2 (M+).
| Tester Connection | Specified Condition |
| 1 (M-) - 2 (M+) | 0.3 to 100 Ω at 20°C (68°F) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - THROTTLE CONTROL MOTOR) |
![]() |
Disconnect the E5 ECM connector.
![]() |
Disconnect the T2 throttle control motor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| 2 (Throttle control motor) - E5-6 (M+) | Below 1 Ω |
| 1 (Throttle control motor) - E5-5 (M-) | Below 1 Ω |
| Tester Connection | Specified Condition |
| 2 (Throttle control motor) or E5-6 (M+) - Body ground | 10 kΩ or higher |
| 1 (Throttle control motor) or E5-5 (M-) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector and the throttle control motor connector.
|
| ||||
| OK | |
| 3.INSPECT THROTTLE W/ MOTOR BODY ASSEMBLY |
Visually check between the throttle valve and the housing for foreign objects.
Also, check if the valve can open and close smoothly.
|
| ||||
| OK | ||
| ||