Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P2610    ECM / PCM Internal Engine Off Timer Performance

for Preparation Click here


MONITOR DESCRIPTION

To check the heat retention of the tank in the coolant heat storage (CHS) system, the ECM may cause the water pump of the CHS system to operate 5 hours after the power switch has been turned OFF.
A timer and a clock are contained in the ECM internal circuit, and the timer starts when the power switch is turned OFF (this process is called the "soak mode").
When the HV main system is started by the power switch, the ECM monitors its internal circuit. If the ECM detects a deviation between the clock and the timer, or an abnormal condition during a comparison between the starting history and the length of time the HV main power has been turned OFF, the ECM determines that its internal circuit has a malfunction and sets a DTC.

DTC No.
DTC Detection Condition
Trouble Area
P2610
ECM internal error
ECM

MONITOR STRATEGY


Related DTCs
P2610: ECM internal engine off timer performance
Required sensors/components (main)
ECM
Frequency of operation
Once per driving cycle
Duration
600 seconds
MIL operation
2 driving cycles
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
None
Engine
Running

TYPICAL MALFUNCTION THRESHOLDS


Case 1 
Time internal engine off timer clock reads when CPU clock has elapsed 600 seconds
Less than 420 seconds or more than 780 seconds

Case 2 
Presents of history that ECM had woken up by internal engine off timer
YES
Time period vehicle has been soaked
Less than programmed period

Case 3 
Presents of history that ECM had woken up by internal engine off timer
NO
Time period vehicle has been soaked
More than or equal to programmed period

INSPECTION PROCEDURE

HINT:
Read freeze frame data using Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air/fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

1.REPLACE ECM

NEXT

REPAIR COMPLETED