Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

DTC    B2797    Communication Malfunction No. 1

for Preparation Click here


DESCRIPTION

This DTC is output when a communication error occurs between the key slot and transponder key ECU. A possible reason for the communication error is that noise is occurring on the communication line. Following the inspection procedure below.

DTC No.
DTC Detection Condition
Trouble Area
B2797
Key has noise occurring on communication line
  1. Key (door control transmitter)
  2. Wire harness
  3. Key slot
  4. Transponder key ECU

WIRING DIAGRAM


B121683E12


INSPECTION PROCEDURE

1.CHECK TRANSPONDER KEY ECU


    B126102E01
  1. Using an oscilloscope or the Techstream, check for noise in the waveform between the terminals of the K3 key slot connector and T5 ECU connector.

    OK:
    No noise is present (see illustration).

    Tester Connection
    Tool Setting
    Condition
    Specified Condition
    T5-21 (CODE) - K3-4 (CODE)
    5 V/DIV., 20 msec./DIV.
    Key inserted
    No noise is present



NG
FIND CAUSE OF NOISE AND REMOVE IT
OK


2.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - KEY SLOT)


    B126099E02
  1. Disconnect the T5 ECU connector.

  1. Disconnect the K3 key slot connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-21 (CODE) - K3-4 (CODE)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK KEY SLOT (OPERATION)
  1. Temporarily replace the key slot with a new or normally functioning one.

  1. Check that the power switch can be turned ON (ACC and IG) and the hybrid control system can be started.

    OK:
    Power switch can be turned ON (ACC and IG) and hybrid control system can be turned.



NG
REPLACE TRANSPONDER KEY ECU
OK

END (KEY SLOT IS DEFECTIVE)