Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2793    Transponder Chip Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when: 1) during key code registration, a key malfunction occurs; or 2) the key code was unable to be registered properly. Follow the inspection procedure below.

DTC No.
DTC Detection Condition
Trouble Area
B2793
Transponder chip malfunction
Key (door control transmitter)

INSPECTION PROCEDURE

1.REREGISTER KEY
  1. Delete the DTC (Click here).

  1. Reregister the key (which caused this DTC to be output) with the transponder key ECU (Click here).

  1. Insert the same key into the key slot.

  1. Check that the power switch can be turned ON (ACC and IG) and the hybrid control system can be started.

    OK:
    Power switch can be turned (ACC and IG) and hybrid control system can be started.



NG
REPLACE KEY
OK

END