ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) > Power Source Circuit |

| 1.CHECK POWER SWITCH (OPERATION) |
Check that the power switch can be turned.
|
| ||||
| OK | |
| 2.INSPECT FUSE (IGN, P CON MAIN, AM2) |
Remove the IGN fuse from the instrument panel junction block.
Remove the P CON MAIN and AM2 fuses from the engine room junction block.
Measure the resistance of the fuses.
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the T5 ECU connector.
Measure the resistance and voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| T5-22 (GND) - Body ground | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| T5-4 (IG) - Body ground | Power switch ON (IG) | 10 to 14 V |
| Power switch OFF | Below 1 V | |
| T5-3 (CPUB) - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | ||
| ||