Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) > Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the transponder key ECU.

WIRING DIAGRAM


B126104E03


INSPECTION PROCEDURE

1.CHECK POWER SWITCH (OPERATION)
  1. Check that the power switch can be turned.

    HINT:
    1. Without depressing the brake pedal, push the power switch repeatedly. Power switch should change as following: OFF→ ON (ACC) → ON (IG) → OFF.
    2. With depressing the brake pedal, push the power switch repeatedly. Power switch should change as following: OFF→ ON (ACC) → ON (IG) → ON (READY) → OFF.



NG
GO TO SMART KEY SYSTEM (for Starting)
OK


2.INSPECT FUSE (IGN, P CON MAIN, AM2)
  1. Remove the IGN fuse from the instrument panel junction block.

  1. Remove the P CON MAIN and AM2 fuses from the engine room junction block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND)


    B126105E01
  1. Disconnect the T5 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-22 (GND) - Body ground
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    T5-4 (IG) - Body ground
    Power switch ON (IG)
    10 to 14 V
    Power switch OFF
    Below 1 V
    T5-3 (CPUB) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE