Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2784    Antenna Coil Open / Short

for Preparation Click here


DESCRIPTION

This DTC is detected when a transponder key coil (antenna coil) is open/shorted.

DTC No.
DTC Detection Condition
Trouble Area
B2784
Antenna coil is open/shorted
  1. Wire harness
  2. Key slot
  3. Transponder key ECU

WIRING DIAGRAM


B121682E14


INSPECTION PROCEDURE

1.READ VALUE OF TECHSTREAM (TRANSPONDER KEY COIL)
  1. Check the Data List for proper functioning of the transponder key coil.

    Transponder Key ECU: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Antenna Coil
    Transponder key coil condition / NORMAL or FAIL
    NORMAL: Transponder key coil is normal
    FAIL: Transponder key coil is malfunctioning
    -

    OK:
    NORMAL (transponder key coil is normal) appears on screen.



OK
REPLACE TRANSPONDER KEY ECU
NG


2.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - KEY SLOT)


    B126099E01
  1. Disconnect the T5 ECU connector.

  1. Disconnect the K3 key slot connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-20 (VC5) - K3-1 (VC5)
    Below 1 Ω
    T5-21 (CODE) - K3-4 (CODE)
    T5-6 (TXCT) - K3-5 (TXCT)
    T5-7 (AGND) - K3-7 (GND)
    T5-20 (VC5) or K3-1 (VC5) - Body ground
    10 kΩ or higher
    T5-21 (CODE) or K3-4 (CODE) - Body ground
    T5-6 (TXCT) or K3-5 (TXCT) - Body ground
    T5-7 (AGND) or K3-7 (GND) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE KEY SLOT