When the transponder key ECU detects that the halfway switch is ON, the ECU provides current to the transponder key coil and produces a faint electric wave. A transponder chip in the key receives the faint electric wave. Upon receiving the faint electric wave, the transponder chip outputs a key ID code signal. The transponder key coil receives this signal, the transponder key amplifier amplifies it, and then the signal is transmitted to the transponder key ECU. The transponder key ECU matches the key's ID code with the vehicle's ID code, which was previously registered in the ECU. If the ID codes match, the transponder key ECU turns off the security indicator. Then when the power switch is pushed, the code match results are sent through the transponder key ECU to the power source control ECU, which authorizes the transition of the power switch's power modes. The ACC, IG1 and IG2 relays are turned ON, supplying power to the power switch ON (ACC) and ON (IG) power modes. Also, the power source control ECU changes the power switch's indicator to amber, informing the driver that the power mode is set to ON (IG). Then, the power source control ECU sends a system start signal to the hybrid vehicle control ECU. The hybrid vehicle control ECU confirms that the key ID code has been verified. If the ID code has been verified, the hybrid vehicle control ECU bypasses the immobiliser system and starts the hybrid control system.