Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

DTC    B2785    Communication Malfunction between ECUs Connected by LIN

for Preparation Click here


DESCRIPTION

This DTC is output if communication between the transponder key ECU and power source control ECU is not possible.

DTC No.
DTC Detection Condition
Trouble Area
B2785
Communication between transponder key ECU and power source control ECU is not possible
  1. Wire harness
  2. Power source control ECU
  3. Transponder key ECU

WIRING DIAGRAM


B126100E02


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - POWER SOURCE CONTROL ECU)


    B126101E01
  1. Reconnect the T5 and P6 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-14 (LIN1) - P6-30 (LIN1)
    Below 1 Ω
    T5-14 (LIN1) or P6-30 (LIN1) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.CHECK TRANSPONDER KEY ECU (OPERATION)
  1. Temporarily replace the transponder key ECU with a new or normally functioning one.

  1. Check that the power switch can be turned ON (ACC and IG) and the hybrid control system can be started.

    OK:
    Power switch can be turned ON (ACC and IG) and hybrid control system can be started.



NG
REPLACE POWER SOURCE CONTROL ECU
OK

END (TRANSPONDER KEY ECU IS DEFECTIVE)