DTC B2785 Communication Malfunction between ECUs Connected by LIN |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2785 | Communication between transponder key ECU and power source control ECU is not possible |
|

| 1.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - POWER SOURCE CONTROL ECU) |
![]() |
Reconnect the T5 and P6 ECU connectors.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| T5-14 (LIN1) - P6-30 (LIN1) | Below 1 Ω |
| T5-14 (LIN1) or P6-30 (LIN1) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK TRANSPONDER KEY ECU (OPERATION) |
Temporarily replace the transponder key ECU with a new or normally functioning one.
Check that the power switch can be turned ON (ACC and IG) and the hybrid control system can be started.
|
| ||||
| OK | ||
| ||