ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the Techstream to the DLC3.
Turn the power switch ON (IG).
Read the Data List by following the directions on the tester screen.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Immobiliser | Immobiliser system status / SET or UNSET | SET: Without key UNSET: Power switch ON (IG) | - |
| Check (Security) | Verification with entry key ECU / NORMAL or ABNORMAL | NORMAL: Verified with entry key ECU ABNORMAL: Not verified with entry key ECU | - |
| Permit (Start) | Hybrid control system starting control / OK or NG | OK: Hybrid control system starting is permitted NG: Hybrid control system is not permitted | - |
| Master Key | Key code signal / NOMATCH or MATCH | MATCH: Key code is send NOMATCH: Unmatched key code is sent | - |
| Regist Mas Code | Number of registered key / min.: 0; max.: 5 | Number of registered key | - |
| +B | Battery voltage / NORMAL or BREAK | NORMAL: Battery supply is normal BREAK: Battery supply is malfunctioning | - |
| Antenna Coil | Transponder key coil condition / NORMAL or FAIL | NORMAL: Transponder key coil is normal FAIL: Transponder key coil is malfunctioning | - |
| G-Code Support | G-code support / SUPPORT or NOT SUP | SUPPORT: G-code is supported NOT SUP: G-code is not supported | - |
| PERFORM ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the power switch ON (IG).
Perform the Active Test by following the directions on the tester's screen.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indic | Turn security indicator light | ON / OFF | - |
| Meter Buzzer | Meter buzzer | ON / OFF | - |
| Not P-Pos Warn | Shift p-pos warning | ON / OFF | - |
| Meter Chime2 | Meter chime | ON / OFF | - |