Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch ON (IG).

  3. Read the Data List by following the directions on the tester screen.

    Transponder Key ECU: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Immobiliser
    Immobiliser system status / SET or UNSET
    SET: Without key
    UNSET: Power switch ON (IG)
    -
    Permit (Start)
    Hybrid control system starting control / OK or NG
    OK: Hybrid control system starting is permitted
    NG: Hybrid control system is not permitted
    -
    Master Key
    Key code signal / NOMATCH or MATCH
    MATCH: Key code is send
    NOMATCH: Unmatched key code is sent
    -
    Regist Mas Code
    Number of registered key / min.: 0; max.: 5
    Number of registered key
    -
    +B
    Battery voltage / NORMAL or BREAK
    NORMAL: Battery supply is normal
    BREAK: Battery supply is malfunctioning
    -
    Antenna Coil
    Transponder key coil condition / NORMAL or FAIL
    NORMAL: Transponder key coil is normal
    FAIL: Transponder key coil is malfunctioning
    -
    G-Code Support
    G-code support / SUPPORT or NOT SUP
    SUPPORT: G-code is supported
    NOT SUP: G-code is not supported
    -


PERFORM ACTIVE TEST

HINT:
Performing the Techstream's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch ON (IG).

  3. Perform the Active Test by following the directions on the tester's screen.

    Transponder Key ECU: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indic
    Turn security indicator light
    ON / OFF
    -
    Meter Buzzer
    Meter buzzer
    ON / OFF
    -
    Not P-Pos Warn
    Shift p-pos warning
    ON / OFF
    -
    Meter Chime2
    Meter chime
    ON / OFF
    -