Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P3000-389    HV Battery Malfunction

for Preparation Click here


DESCRIPTION

Based on the malfunction signal received from the battery ECU, the system alerts the driver and effects fail-safe control.
This DTC is output if the HV battery is depleted or the HV control system has malfunction.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3000
389
Abnormal signal input from battery ECU (drop of high voltage)
  1. HV control system
  2. HV battery assembly

INSPECTION PROCEDURE

1.READ OUTPUT DTC (HV ECU)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTC P3000 (INF 389) and other DTCs are output

    HINT:
    If any other codes besides P3000 (INF 389) are output, perform troubleshooting for those DTCs first.



YES
GO TO RELEVANT DTC CHART
NO


2.CHECK IF ENGINE STARTS
  1. Turn the power switch ON (READY).

  1. Check if the engine starts.

    OK:
    The engine starts



NG
REPLACE HV SUPPLY BATTERY ASSEMBLY
OK

LEAVE VEHICLE IN P POSITION, AND CHARGE HV BATTERY IN IDLE STATUS UNTIL IDLING STOPS