Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P3000-123    HV Battery Malfunction

DTC    P3000-125    HV Battery Malfunction

DTC    P3000-603    HV Battery Malfunction

for Preparation Click here


DESCRIPTION

The HV control ECU gives warning to the driver and performs the fail-safe control, according to the abnormal signal received from the battery ECU.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3000
123
Abnormal signal input from battery ECU (HV battery system malfunction)
  1. HV battery system
  2. Battery ECU
P3000
125
Abnormal signal input from battery ECU (High voltage fuse blown out)
  1. HV battery system
  2. Battery ECU
P3000
603
Abnormal signal input from battery ECU (HV battery cooling system malfunction)
  1. HV battery system
  2. Battery ECU

INSPECTION PROCEDURE

HINT:
After repairing the malfunction, restart the system (to turn the READY light ON) and recheck the DTCs.

1.READ OUTPUT DTC (HV BATTERY)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTCs are output



YES
GO TO RELEVANT DTC CHART
NO

REPLACE BATTERY ECU ASSEMBLY