Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P3000-388    HV Battery Malfunction

for Preparation Click here


DESCRIPTION

Based on the malfunction signal received from the battery ECU, the system alerts the driver and effects fail-safe control.
This DTC is output when the SOC (state of charge) of the HV battery decreases as a result of leaving the vehicle in the N position, running out of fuel, or malfunction in the HV control system.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3000
388
Abnormal signal input from battery ECU (discharge inhibition control malfunction)
  1. HV control system
  2. Fuel shortage
  3. HV battery assembly

INSPECTION PROCEDURE

1.READ OUTPUT DTC (HV ECU)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTC P3000 (INF 388) and other DTCs are output

    HINT:
    If any other codes besides P3000 (INF 388) are output, perform troubleshooting for those DTCs first.



YES
GO TO RELEVANT DTC CHART
NO


2.CHECK AMOUNT OF GASOLINE
  1. Turn the power switch ON (IG).

  1. Check the amount of gasoline with the fuel gauge in the meter.

    OK:
    Appropriate amount of gasoline



NG
REFUEL GASOLINE
OK


3.CHECK IF ENGINE STARTS
  1. Turn the power switch ON (READY).

  1. Check if the engine starts.

    OK:
    The engine starts



NO
REPLACE HV SUPPLY BATTERY ASSEMBLY
YES

LEAVE VEHICLE IN P POSITION, AND CHARGE HV BATTERY IN IDLE STATUS UNTIL IDLING STOPS