Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P3107-213    Airbag ECU Communication Circuit Malfunction

DTC    P3107-214    Airbag ECU Communication Circuit Malfunction

DTC    P3107-215    Airbag ECU Communication Circuit Malfunction

for Preparation Click here


DESCRIPTION

The HV control ECU detects a malfunction of the collision signal circuit from the center airbag sensor and gives warning to the driver.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3107
213
GND short in communication circuit between center airbag sensor and HV control ECU
  1. Wire harness or connector
  2. Center airbag sensor
P3107
214
Open or +B short in communication circuit between center airbag sensor and HV control ECU
  1. Wire harness or connector
  2. Center airbag sensor
P3107
215
Abnormal communication signals between center airbag sensor and HV control ECU
  1. Wire harness or connector
  2. Center airbag sensor

WIRING DIAGRAM


A092110E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - CENTER AIRBAG SENSOR)


    A065748E37
  1. Disconnect the H14 HV control ECU connector.



    A092062E02
  1. Disconnect the A18 center airbag sensor connector.

  1. Turn the power switch ON (IG).

  1. Measure the voltage between the terminal of the HV control ECU connector and body ground.

    Standard voltage:
    Tester Connection
    Specified Condition
    ABFS (H14-20) - Body ground
    Below 1 V

  1. Turn the power switch OFF.

  1. Measure the resistance between the wire harness side connectors.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    ABFS (H14-20) - GSW2 (A18-22)
    Below 1 Ω
    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    ABFS (H14-20) or GSW2 (A18-22) - Body ground
    10 kΩ or higher

  1. Reconnect the center airbag sensor connector.

  1. Reconnect the HV control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CENTER AIRBAG SENSOR