Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P3110-223    IGCT Relay Malfunction

DTC    P3110-527    HV Main Relay Malfunction

for Preparation Click here


DESCRIPTION

The HV control ECU monitors the IGCT relay and IG2 relay to detect malfunction.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3110
223
IGCT relay is always closed
  1. Wire harness or connector
  2. Integration relay (IGCT relay)
P3110
527
IG2 logical inconsistency
  1. Wire harness or connector
  2. Integration relay (IG2 relay)

WIRING DIAGRAM

Refer to the wiring diagram for the IG2 relay .

A092111E02


INSPECTION PROCEDURE

HINT:
If there is a battery voltage at the +B, MREL or IGSW terminal of the HV control ECU even though the power switch is turned OFF, the circuit is shorted to the +B power supply.

1.INSPECT INTEGRATION RELAY (IGCT RELAY AND IG2 RELAY)


    A093724E02
  1. Remove the integration relay from the engine room relay block.

  1. Inspect the IGCT relay.

    1. Measure the resistance between the terminals of the integration relay.

      Standard resistance:
      Tester Connection
      Specified Condition
      A4 - C1
      10 kΩ or higher
      A4 - C1
      Below 1 Ω
      (Apply battery voltage to terminals A2 and A3)

  1. Inspect the IG2 relay.

    1. Measure the resistance between the terminals of the integration relay.

      Standard resistance:
      Tester Connection
      Specified Condition
      B4 - C1
      10 kΩ or higher
      B4 - C1
      Below 1 Ω
      (Apply battery voltage to terminals B2 and B3)



NG
REPLACE INTEGRATION RELAY (IGCT RELAY OR IG2 RELAY)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (HV CONTROL ECU - INTEGRATION RELAY)