Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0AA1-233    Hybrid Battery Positive Contactor Circuit Stuck Closed

for Preparation Click here


DESCRIPTION

Refer to DTC P0AE7 (INF 224) .
Because it might be impossible to shut off the high-voltage system if any one of the No. 1 to No. 3 system main relays becomes stuck, the HV control ECU monitors the 3 relays and stops the system if malfunction is found in either relay.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0AA1
233
System main relay terminals of HV battery positive and negative sides stuck closed
  1. No. 1 system main relay
  2. No. 2 system main relay
  3. No. 3 system main relay

INSPECTION PROCEDURE

CAUTION:
  1. Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip. After removing the service plug grip, put it in your pocket to prevent other technicians from reconnecting it while you are servicing the high-voltage system.
  2. After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals.

HINT:
At least 5 minutes are required to discharge the high-voltage condenser inside the inverter.

1.INSPECT NO. 1 SYSTEM MAIN RELAY
  1. Inspect the No. 1 system main relay .



NG
REPLACE NO. 1 SYSTEM MAIN RELAY
OK


2.INSPECT NO. 2 SYSTEM MAIN RELAY
  1. Inspect the No. 2 system main relay .



NG
REPLACE NO. 2 SYSTEM MAIN RELAY
OK

REPLACE NO. 3 SYSTEM MAIN RELAY