Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0AA4-232    Hybrid Battery Negative Contactor Circuit Stuck Closed

for Preparation Click here


DESCRIPTION

Refer to DTC P0AE7 (INF 224) .

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0AA4
232
System main relay terminal of HV battery negative side stuck closed
  1. No. 3 system main relay

MONITOR DESCRIPTION

The HV control ECU monitors the No. 3 system main relay, because shutting off the high-voltage system might be impossible if the relay terminal becomes stuck. If the HV control ECU detects that the relay terminal has stuck closed, it illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0AA4 (INF 232): SMR circuit / "-" side stuck
Required sensor / components
No. 3 system main relay
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TOYOTA's intellectual property
-

COMPONENT OPERATING RANGE


No. 3 system main relay
DTC P0AA4 (INF 232) is not detected

INSPECTION PROCEDURE

If the information (INF) code is present, replace the No. 3 system main relay.
1.REPLACE NO. 3 SYSTEM MAIN RELAY
  1. Replace the No. 3 system main relay .


NEXT

COMPLETED