Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P3108-535    A/C Amplifier Communication Circuit Malfunction

DTC    P3108-536    A/C Amplifier Communication Circuit Malfunction

DTC    P3108-538    A/C Amplifier Communication Circuit Malfunction

for Preparation Click here


DESCRIPTION

The HV control ECU detects a wiring malfunction in the serial communication line of the A/C inverter.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3108
535
Serial communication malfunction
  1. Wire harness or connector
  2. Inverter with converter assembly
P3108
536
A/C inverter malfunction
  1. Wire harness or connector
  2. Inverter with converter assembly
P3108
538
Open in STB signal circuit
  1. Wire harness or connector
  2. Inverter with converter assembly

WIRING DIAGRAM


A014137E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - A/C INVERTER)


    A090418E01
  1. Disconnect the H15 and H16 HV control ECU connectors.



    A092056E02
  1. Disconnect the I11 A/C inverter connector.

  1. Turn the power switch ON (IG).

  1. Measure the voltage between the terminals of the HV control ECU connector and body ground.

    Standard voltage:
    Tester Connection
    Specified Condition
    CLK (H16-17) - Body ground
    Below 1 V
    ITE (H16-14) - Body ground
    Below 1 V
    ETI (H15-24) - Body ground
    Below 1 V
    STB (H15-25) - Body ground
    Below 1 V

  1. Turn the power switch OFF.

  1. Measure the resistance between the wire harness side connectors.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    CLK (H16-17) - CLK (I11-4)
    Below 1 Ω
    ITE (H16-14) - TOECU (I11-2)
    Below 1 Ω
    ETI (H15-24) - TOINV (I11-3)
    Below 1 Ω
    STB (H15-25) - STB (I11-5)
    Below 1 Ω
    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    CLK (H16-17) or CLK (I11-4) - Body ground
    10 kΩ or higher
    ITE (H16-14) or TOECU (I11-2) - Body ground
    10 kΩ or higher
    ETI (H15-24) or TOINV (I11-3) - Body ground
    10 kΩ or higher
    STB (H15-25) or STB (I11-5) - Body ground
    10 kΩ or higher

  1. Reconnect the A/C inverter connector.

  1. Reconnect the HV control ECU connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INVERTER WITH CONVERTER ASSEMBLY