Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P3137-348    Collision Sensor Low Input

DTC    P3138-349    Collision Sensor High Input

for Preparation Click here


DESCRIPTION

The HV control ECU checks the line connection of the circuit breaker sensor (collision sensor) signal and gives warning to the driver if malfunction is detected.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3137
348
GND short in No. 1 circuit breaker sensor circuit
  1. Wire harness or connector
  2. No. 1 circuit breaker sensor
P3138
349
Open or +B short in No. 1 circuit breaker sensor circuit
  1. Wire harness or connector
  2. No. 1 circuit breaker sensor

WIRING DIAGRAM


A092112E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - NO. 1 CIRCUIT BREAKER SENSOR)


    A065745E49
  1. Disconnect the H16 HV control ECU connector.



    A092057E02
  1. Disconnect the C3 No. 1 circuit breaker sensor connector.

  1. Turn the power switch ON (IG).

  1. Measure the voltage between the terminals of the HV control ECU connector and body ground.

    Standard voltage:
    Tester Connection
    Specified Condition
    AS1 (H16-15) - Body ground
    Below 1 V
    AS1G (H16-16) - Body ground
    Below 1 V

  1. Turn the power switch OFF.

  1. Measure the resistance between the wire harness side connectors.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    AS1 (H16-15) - SIF+ (C3-2)
    Below 1 Ω
    AS1G (H16-16) - SIF- (C3-1)
    Below 1 Ω
    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    AS1 (H16-15) or SIF+ (C3-2) - Body ground
    10 kΩ or higher
    AS1G (H16-16) or SIF- (C3-1) - Body ground
    10 kΩ or higher

  1. Reconnect the No. 1 circuit breaker sensor connector.

  1. Reconnect the HV control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE NO. 1 CIRCUIT BREAKER SENSOR