DTC P0A78-304 Drive Motor "A" Inverter Performance |
DTC P0A78-305 Drive Motor "A" Inverter Performance |
DTC P0A78-507 Drive Motor "A" Inverter Performance |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0A78 | 304 | Open or +B short in motor gate shutdown (MSDN) signal circuit |
|
| P0A78 | 305 | GND short in motor gate shutdown (MSDN) signal circuit |
|
| P0A78 | 507 | Open in motor gate shutdown (MSDN) signal circuit |
|
| Related DTCs | P0A78 (INF 304 / 305 / 507): Motor inverter / Motor gate shutdown signal malfunction |
| Required sensor / components | Motor inverter |
| Frequency of operation | Continuous |
| Duration | TOYOTA's intellectual property |
| MIL operation | 1 driving cycle |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | TOYOTA's intellectual property |
| Other conditions belong to TOYOTA's intellectual property | - |
| Motor gate shutdown signal circuit | Open or short |
| Motor inverter | DTC P0A78 (INF 304 / 305 / 507) is not detected |

| 1.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - INVERTER) |
![]() |
Turn the power switch OFF.
Remove the service plug grip .
![]() |
Disconnect the H15 HV control ECU connector.
Remove the inverter cover .
Disconnect the I10 inverter connector.
Turn the power switch ON (IG).
Measure the voltage between the terminal of the HV control ECU connector and body ground.
| Tester Connection | Specified Condition |
| MSDN (H15-8) - Body ground | Below 1 V |
Turn the power switch OFF.
Measure the resistance between the wire harness side connectors.
| Tester Connection | Specified Condition |
| MSDN (H15-8) - MSDN (I10-25) | Below 1 Ω |
| Tester Connection | Specified Condition |
| MSDN (H15-8) or MSDN (I10-25) - Body ground | 10 kΩ or higher |
Reconnect the inverter connector.
Reconnect the HV control ECU connector.
Reinstall the inverter cover .
Reinstall the service plug grip .
|
| ||||
| OK | ||
| ||