Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A78-523    Drive Motor "A" Inverter Performance

for Preparation Click here


DESCRIPTION

Refer to DTC P0A78 (INF 266) .

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A78
523
Inverter voltage (VH) sensor offset malfunction
  1. System main relay
  2. Inverter with converter assembly

MONITOR DESCRIPTION

The HV control ECU monitors the inverter voltage (VH) sensor signal. If the HV control ECU detects a fault in the sensor signal, the HV control ECU interprets this as a VH sensor failure. The HV control ECU then illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A78 (INF 523): Voltage (VH) malfunction
Required sensor / components
Motor inverter, battery ECU
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TOYOTA's intellectual property
-

COMPONENT OPERATING RANGE


Motor inverter
DTC P0A78 (INF 523) is not detected

INSPECTION PROCEDURE

CAUTION:
  1. Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip. After removing the service plug grip, put it in your pocket to prevent other technicians from reconnecting it while you are servicing the high-voltage system.
  2. After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals.

HINT:
At least 5 minutes are required to discharge the high-voltage condenser inside the inverter.

1.READ OUTPUT DTC (HV ECU)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTC P0A78 (INF 523) and other DTCs are output

    HINT:
    If any other codes besides P0A78 (INF 523) are output, perform troubleshooting for those DTCs first.



YES
GO TO RELEVANT DTC CHART
NO


2.CHECK SYSTEM MAIN RELAYS FOR STICKING

CAUTION:
Wear insulated gloves before performing the following operation.

  1. Turn the power switch OFF.

  1. Remove the service plug grip .

    NOTICE:
    Turning the power switch ON (READY) with the service plug grip removed could cause malfunction. Therefore, never turn the power switch ON (READY) in this state.



    A087664E02
  1. Disconnect all the high-voltage terminals of the system main relays.

  1. Measure the resistance at the switch side of the system main relays.

    Standard resistance:
    10 kΩ or higher

  1. Connect the high-voltage terminals of the system main relays.

  1. Reinstall the service plug grip .



NG
REPLACE STUCK SYSTEM MAIN RELAY
OK

REPLACE INVERTER WITH CONVERTER ASSEMBLY