DTC P0A7A-522 Generator Inverter Performance |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0A7A | 522 | Generator inverter gate malfunction |
|
| Related DTCs | P0A7A (INF 522): Malfunction of Inverter gate shutdown circuit |
| Required sensors / components | Generator inverter |
| Frequency of operation | Continuous |
| Duration | TOYOTA's intellectual property |
| MIL operation | Immediately |
| Sequence of operation | None |
| The monitor will run whenever the DTCs listed are not present | TOYOTA's intellectual property |
| Other conditions belong to TOYOTA's intellectual property | - |
| TOYOTA's intellectual property | - |
| Generator inverter | DTC P0A7A (INF 522) is not detected |
| 1.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - INVERTER) |
Turn the power switch OFF.
Remove the service plug grip .
![]() |
Disconnect the H15 HV control ECU connector.
Remove the inverter cover .
![]() |
Disconnect the I10 inverter connector.
Turn the power switch ON (IG).
Measure the voltage between the terminal of the HV control ECU connector and body ground.
| Tester Connection | Specified Condition |
| GSDN (H15-16) - Body ground | Below 1 V |
Turn the power switch OFF.
Measure the resistance between the wire harness side connectors.
| Tester Connection | Specified Condition |
| GSDN (H15-16) - GSDN (I10-20) | Below 1 Ω |
| Tester Connection | Specified Condition |
| GSDN (H15-16) or GSDN (I10-20) - Body ground | 10 kΩ or higher |
Reconnect the inverter connector.
Reconnect the HV control ECU connector.
Reinstall the inverter cover .
Reinstall the service plug grip .
|
| ||||
| OK | ||
| ||