Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A90-251    Drive Motor "A" Performance

for Preparation Click here


DESCRIPTION

When three-phase alternating current flows through the three-phase windings of the stator coil, a rotating magnetic field is generated in the motor. The system controls the rotating magnetic field in accordance with the rotating position and speed of the rotor. As a result, the permanent magnets provided on the rotor are pulled in the rotating direction, which cause the generation of torque.
The generated torque is practically proportionate to the amount of current. Therefore, the system controls the speed of the motor by regulating the frequency of the alternating current. Furthermore, the system properly controls the rotating magnetic field and the angle of the rotor magnets in order to generate high torque in an efficient manner, even at high speeds.

A093725E04


DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A90
251
MG2 magnetic force deterioration or same phase short circuit
  1. Hybrid vehicle motor

MONITOR DESCRIPTION

The HV control ECU monitors the hybrid vehicle motor (MG2). If the HV control ECU detects a reduction in the magnetic force of the MG2 or an in-phase short, it interprets this as a MG2 failure. The HV control ECU then illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A90 (INF 251):
Magnetic force deterioration/same phase short circuit
Required sensor / components
Hybrid vehicle motor, inverter, motor resolver
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TOYOTA's intellectual property
-

COMPONENT OPERATING RANGE


Hybrid vehicle motor
DTC P0A90 (INF 251) is not detected

INSPECTION PROCEDURE

1.READ OUTPUT DTC (HV ECU)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTC P0A90 (INF 251) and other DTCs are output

    HINT:
    If any other codes besides P0A90 (INF 251) are output, perform troubleshooting for those DTCs first.



YES
GO TO RELEVANT DTC CHART
NO

REPLACE HYBRID VEHICLE MOTOR ASSEMBLY