DTC P0A90-509 Drive Motor "A" Performance |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0A90 | 509 | MG2 system malfunction |
|
| Related DTCs | P0A90 (INF 509): Motor system malfunction |
| Required sensor / components | Hybrid vehicle motor, inverter, motor resolver |
| Frequency of operation | Continuous |
| Duration | TOYOTA's intellectual property |
| MIL operation | Immediately |
| Sequence of operation | None |
| The monitor will run whenever the following | TOYOTA's intellectual property |
| DTCs are not present No other condition | - |
| TOYOTA's intellectual property | - |
| Hybrid vehicle motor | DTC P0A90 (INF 509) is not detected |
| 1.READ OUTPUT DTC (HV ECU) |
Connect the Techstream to the DLC3.
Turn the power switch ON (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
|
| ||||
| NO | |
| 2.INSPECT HYBRID VEHICLE MOTOR ASSEMBLY |
Turn the power switch OFF.
Remove the service plug grip .
Remove the inverter cover .
![]() |
Disconnect the three-phase alternating current cable for the hybrid vehicle motor from the inverter.
Using a milliohm meter, measure the resistance between the three-phase alternating current cable terminals of the hybrid vehicle motor.
| Tester Connection | Specified Condition* |
| U (I14-1) - V (I14-2) | Below 135 mΩ at 68°F (20°C) |
| V (I14-2) - W (I14-3) | Below 135 mΩ at 68°F (20°C) |
| W (I14-3) - U (I14-1) | Below 135 mΩ at 68°F (20°C) |
Calculate the difference between the maximum and minimum resistance between terminals U - V, V - W, and W - U.
Using a megohmmeter, measure the insulation resistance between the three-phase alternating current cable terminals of the hybrid vehicle motor and the body ground.
| Tester Connection | Specified Condition |
| U (I14-1) - Body ground | 10 MΩ or higher |
| V (I14-2) - Body ground | 10 MΩ or higher |
| W (I14-3) - Body ground | 10 MΩ or higher |
Reconnect the three-phase alternating current cable for the hybrid vehicle motor.
Reinstall the inverter cover .
Reinstall the service plug grip .
|
| ||||
| OK | ||
| ||