Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A92-261    Hybrid Generator Performance

for Preparation Click here


DESCRIPTION

See the description of the MG1/MG2 .

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A92
261
MG1 magnetic force deterioration or same phase short circuit
  1. Hybrid vehicle generator

MONITOR DESCRIPTION

The HV control ECU monitors the hybrid vehicle generator (MG1). If the HV control ECU detects a reduction in the magnetic force of the MG1 or an in-phase short, it interprets this as a MG1 failure. The HV control ECU then illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A92 (INF 261):
Magnetic force deterioration/same phase short circuit
Required sensor / components
Hybrid vehicle generator, inverter, generator resolver
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TOYOTA's intellectual property
-

COMPONENT OPERATING RANGE


Hybrid vehicle generator
DTC P0A92 (INF 261) is not detected

INSPECTION PROCEDURE

1.READ OUTPUT DTC (HV ECU)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTC P0A92 (INF 261) and other DTCs are output

    HINT:
    If any other codes besides P0A92 (INF 261) are output, perform troubleshooting for those DTCs first.



YES
GO TO RELEVANT DTC CHART
NO

REPLACE HYBRID VEHICLE GENERATOR ASSEMBLY