DTC P0A94-551 DC / DC Converter Performance |
DTC P0A94-552 DC / DC Converter Performance |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0A94 | 551 | Open or GND short in boost converter fail (FCV) signal circuit |
|
| P0A94 | 552 | +B short in boost converter fail (FCV) signal circuit |
|
| Related DTCs | P0A94 (INF 551 / 552): Boost converter / Converter Finv detection |
| Required sensor / components | Boost converter |
| Frequency of operation | Continuous |
| Duration | TOYOTA's intellectual property |
| MIL operation | 1 driving cycle |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | TOYOTA's intellectual property |
| Other conditions belong to TOYOTA's intellectual property | - |
| Boost converter fail signal circuit | Open or short |
| Boost converter | DTC P0A94 (INF 551 / 552) is not detected |

| 1.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - INVERTER) |
Turn the power switch OFF.
Remove the service plug grip .
![]() |
Disconnect the H16 HV control ECU connector.
Remove the inverter cover .
![]() |
Disconnect the I10 inverter connector.
Turn the power switch ON (IG).
Measure the voltage between the terminals of the HV control ECU connector and body ground.
| Tester Connection | Specified Condition |
| FCV (H16-20) - Body ground | Below 1 V |
| GCNV (H16-8) - Body ground | Below 1 V |
Turn the power switch OFF.
Measure the resistance between the wire harness side connectors.
| Tester Connection | Specified Condition |
| FCV (H16-20) - FCV (I10-30) | Below 1 Ω |
| GCNV (H16-8) - GCNV (I10-32) | Below 1 Ω |
| Tester Connection | Specified Condition |
| FCV (H16-20) or FCV (I10-30) - Body ground | 10 kΩ or higher |
| GCNV (H16-8) or GCNV (I10-32) - Body ground | 10 kΩ or higher |
Reconnect the inverter connector.
Reconnect the HV control ECU connector.
Reinstall the inverter cover .
Reinstall the service plug grip .
|
| ||||
| OK | ||
| ||