Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0338-600    Crankshaft Position Sensor "A" Circuit High Input

DTC    P0343-601    Camshaft Position Sensor "A" Circuit High Input

for Preparation Click here


DESCRIPTION

Refer to DTC P0336 (INF 137) .

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0338
600
NEO signal circuit malfunction
  1. Wire harness or connector
  2. HV control ECU
P0343
601
GO signal circuit malfunction
  1. Wire harness or connector
  2. HV control ECU

WIRING DIAGRAM

Refer to DTC P0336 (INF 137) .

INSPECTION PROCEDURE

1.READ OUTPUT DTC (ENGINE)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Engine Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTCs are output



YES
GO TO RELEVANT DTC CHART
NO


2.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - ECM)


    A065745E34
  1. Disconnect the H16 HV control ECU connector.



    A065744E18
  1. Disconnect the E7 ECM connector.

  1. Measure the resistance between the wire harness side connectors.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    NEO (H16-12) - NEO (E7-1)
    Below 1 Ω
    GO (H16-13) - GO (E7-2)
    Below 1 Ω
    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    NEO (H16-12) or NEO (E7-1) - Body ground
    10 kΩ or higher
    GO (H16-13) or GO (E7-2) - Body ground
    10 kΩ or higher

  1. Reconnect the ECM connector.

  1. Reconnect the HV control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT OUTPUT WAVEFORM


  1. Inspect the ECM using an oscilloscope.



      A133405E02
    1. While the engine is idling, check the waveform between the terminals of the HV control ECU connector.

      Standard voltage:
      Tester Connection
      Specified Condition
      NEO (H16-12) - GND1 (H14-1)
      Correct waveform appears as shown
      GO (H16-13) - GND1 (H14-1)
      Correct waveform appears as shown



NG
REPLACE ECM
OK

REPLACE HYBRID VEHICLE CONTROL ECU