Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1D-159    Hybrid Powertrain Control Module

DTC    P0A1D-160    Hybrid Powertrain Control Module

for Preparation Click here


DESCRIPTION

The HV control ECU performs self-checks to detect an internal operating malfunction in the ECU.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1D
159
160
HV control ECU internal error
  1. HV control ECU

MONITOR DESCRIPTION

The HV control ECU performs many diagnostic tests to verify proper operation of internal and external ECU systems. In one of these monitors, the HV control ECU checks the motor main CPU serial communication link.
If the HV control ECU detects a failure, it will conclude that there is an internal malfunction involving the HV control ECU to motor main CPU communication link. The HV control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A1D (INF 159 / 160):
Motor CPU serial communication error
Required sensor / components
Hybrid vehicle control ECU
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


Hybrid vehicle control ECU
Internal error

COMPONENT OPERATING RANGE


Hybrid vehicle control ECU
DTC P0A1D (INF 159 / 160) is not detected

INSPECTION PROCEDURE

If any of the above information (INF) codes is present, replace the HV control ECU.
1.REPLACE HYBRID VEHICLE CONTROL ECU
  1. Replace the hybrid vehicle control ECU .


NEXT

COMPLETED