Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1F-123    Battery Energy Control Module

for Preparation Click here


DESCRIPTION

Based on a malfunction signal received from the battery ECU, the HV control ECU alerts the driver and effects fail-safe control.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1F
123
Abnormal signal input from battery ECU (ROM/RAM malfunction)
  1. HV battery system
  2. Battery ECU

MONITOR DESCRIPTION

Upon receiving an abnormal signal input from the battery ECU, the HV control ECU illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A1F (INF 123): Battery ECU / Rationality
Required sensor / components
Battery ECU, battery current sensor
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TOYOTA's intellectual property
-

COMPONENT OPERATING RANGE


Battery ECU
Normal

INSPECTION PROCEDURE

HINT:
After repairing the malfunction, restart the system (to turn the READY light ON) and recheck the DTC.

1.READ OUTPUT DTC (HV BATTERY)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTCs are output



YES
GO TO RELEVANT DTC CHART
NO

REPLACE BATTERY ECU ASSEMBLY